wang191 wrote:So i istalled the drivers and the gider plugin.
girder sees the commands my remote sends ot the transciever.
THen i went to the plugin config and hit "learn"
Only code1: is being filled. Code2 stays empty. then i hit test and my tv is not turning off. I tried number keys as well. Nothing is happening. I tried all the carrier frequencies too.
Is this not sending commands or is it not recieving the proper commands?
i also did the force raw learning as well.
1. The first thing you'll want to try is putting the 'repeat' value to a higher number before hitting the 'Test' button. Try a repeat value of 15 for starters.
2. When learning a button, remember to press and HOLD the remote button until learning is finished.
3. For now, always 'Force RAW'.
4. When you hit the TEST button, the Red LED on the USB-UIRT should light up. This indicates that the USB-UIRT is transmitting IR.
5. Try the 36, 38, and 40KHz frequencies first.
6. Make sure the USB-UIRT is pointed towards your TV.
If none of this works, post the make/model of your TV. Also, please send an 'IR Debug' of your TV off button (press the IR Debug button and then press and HOLD the remote button and paste the hex dump to your posting.)
-Jon