I don't know if this is a problem with Girder, UIRT or what, but, I have a problem learning IR codes from this remote to train Girder.
I can learn (raw) and transmit IR from the USB-UIRT. I know this works (most of the time) by clicking the Test button in the settings. When I try to get Girder to learn the IR from this remote, I get a large variance of codes (over 6). This ends up in giving me a large number of events for each remote button - doesn't seem right and doesn't work most of the time.
I searched here and on the Girder forum, but found no solution. I am using a powered USB hub, but I get the same problem whether it is powered or not (I disabled the plugin and re-enabled it before and after). I am not getting any spurious IR; I tested this by leaving on the UIRT learning mode on for over an hour.
This remote seems to generate a sequence of commands depending upon what was pressed before??
Any ideas?
TIA