Dish Network and SageTV

Issues relating to installation of your USB-UIRT device.

Moderator: jrhees

Dish Network and SageTV

Postby linus » Tue Aug 05, 2008 10:41 pm

I just purchased the USB-UIRT to control my dish network DVR-625 (TV1) with SageTV.
I was able to get the USB-UIRT to learn the remote code by using the helper utility from USB-UIRT. I tested the transmission of the codes via the utility program and it changed the channels of the stb correctly.

I believe I set everything up in Sage correctly, but Sage does not appear to transmit the signal to the set top box through the USB-UIRT.

I tested changing stations using a keyboard in the SageTV guide, using a hauppauge remote, and I attempted using the DishNetwork remote.
None work correctly.
The keyboard changes the stations in the program, but it never changes the STB.

Any ideas? I imagine its something simple, but I don't really know what I am doing.

Posts: 2
Joined: Tue Aug 05, 2008 10:29 pm

Postby linus » Thu Aug 07, 2008 1:57 am


I tried running through Sage set-up again, but I still have the same problem.
A red light is definitely emitted when change channels using the keyboard.

How close should the USB-UIRT be to the stb?
Will a trial version of the program make a difference?

Posts: 2
Joined: Tue Aug 05, 2008 10:29 pm

Postby lmwashere » Mon Nov 23, 2009 3:50 am

check out this link to a similar post in the LMCE forums. I was having the same problems. ... 3#msg58963

Not sure if you can enter Pronto codes in your setup, but it is a start.
Posts: 3
Joined: Sun Aug 16, 2009 4:41 pm

Return to Installation

Who is online

Users browsing this forum: No registered users and 1 guest