Page 1 of 1

Software Recommendations?

PostPosted: Wed Mar 17, 2010 12:22 am
by mgsb
I’m looking for software to work with my USB-UIRT, and was wondering if anyone has any recommendations based on my requirements.

I have two different remote controls: the proprietary remote for my AV device, and an OEM remote with pre-programmed codes. I need my PC / USB-UIRT to learn and receive one code from my OEM remote, and then respond to receiving that code by emitting the code learned from my proprietary remote. As far as I can tell, both remotes should work within the frequency range of USB-UIRT.

That’s all I need it to do, so I’d like to avoid paying a lot for extra software functionality that I don’t need. I’m leaning towards buying IRCommand2, but I want to make sure it will do what I need.

If anyone has any suggestions, I’d appreciate it! Thanks.

PostPosted: Sun Apr 18, 2010 10:41 am
by jpl56
I think Intelliremote, can do it.
Shareware, free evaluation, cheap registeration, very good support.

PostPosted: Mon Apr 19, 2010 2:19 am
by mgsb
Thanks for the suggestion. I'll check it out.

Touch IR+

PostPosted: Sun May 09, 2010 4:17 am
by touchpro43
If you'd like to have control of your USB-UIRT from an iPhone/iPod Touch, check out Touch IR+. It can even interface with IRCommand2. http://touch-ir.webs.com.

PostPosted: Fri May 14, 2010 1:45 pm
by davidgreem
Following are the list of softwares that works smoothly without any trouble with USB UIRT such as

1.TCI200B GUI Remote Control 1.02.001.
2.Chipmunk AV Controller 2.0.2687.24109.