Posted: Mon Sep 27, 2004 12:37 pm
I have everything working, but with a few caveats. I am using this with a dish network set top box, and can successfully change channels. However, irsend times out when it sends a command, even though it completes successfully. If I use a different codeset, I do not get timeout errors. I suspect that the driver for the USB-UIRT isn't sending an ACK back, but I haven't trudged through the code enough to assertain if this is accurate. Below is a copy of my lircd.conf file:
Any help that you can provide would be great, since it takes almost 5 seconds to do a channel change, and as such, is not very reliable. It works about 70% of the time.
Thanks!
Travis
- Code: Select all
begin remote
name DISH_3100
bits 16
flags SPACE_ENC
eps 30
aeps 100
header 400 6100
one 400 1700
zero 400 2800
ptrail 400
gap 6200
min_repeat 4
toggle_bit 0
frequency 40000
begin codes
power 0x0000000000000800
0 0x0000000000004400
1 0x0000000000001000
2 0x0000000000001400
3 0x0000000000001800
4 0x0000000000002000
5 0x0000000000002400
6 0x0000000000002800
7 0x0000000000003000
8 0x0000000000003400
9 0x0000000000003800
up 0x0000000000006800
cancel 0x0000000000004800
end codes
end remote
Any help that you can provide would be great, since it takes almost 5 seconds to do a channel change, and as such, is not very reliable. It works about 70% of the time.
Thanks!
Travis