USB-UIRT Forum

Has anyone run into this? Or is anyone even using this setup?

I have my USB-UIRT connected to my SageTV server running Vista. This is a new install of Vista and a "restore" of SageTV from my previous XP install. I really only copied the WIZ.BIN from the old install. So it's really a fresh install.

If I run SageTV in service mode, the USB-UIRT will EITHER receive signals OR send, but never both. Usually, it will send and not receive. This all worked flawlessly on XP (I know, I know, but I've gone down the path). I am hoping to solve this as everything else is working quite well.

If I run SageTV NOT in service mode, everything works as expected.

Any thoughts?

Thanks

i'm having the same exact issue - has anyone figured out a solution?

I am also having this issue...anything that can be done?

I use Sage in service mode on Vista. It will work for a little while then while I'm in the midlle of navigating menus, it stops working> I have to reboot or go to control panel to disable and re-enable the USBUIRT... which doesn't always work. Worked fine on xp for years with no issues. I hope someone has some ideas.

bump