Page 1 of 1

Channel chaning issues

PostPosted: Wed Jan 09, 2008 2:48 am
by nettech_gt

I use Sage TV and sometimes when I select a channel from the guide or I manually input into the remote and the USB UIRT sends the commands to slow the STB tunes to the closest channel it can find. For example I select 182 from guide the USB UIRT inputs 82. So now the channel I'm viewing is 82 but Sage thinks its 182. When this happens sometimes if I press stop and then select it again it will re tune on another STB. However most of the time (after pressing stop) when I re select the same channel it doesn't do anything. This also happens with recordings. Sage often records the wrong show because of this issue. Any ideas? THANX!

PostPosted: Wed Jan 30, 2008 6:27 pm
by jrhees
Youll want to try changing the timing setting is Sage. Increase or decrease the delay between digits to see if this helps


PostPosted: Mon Jul 19, 2010 4:51 am
by vhurst
Ever get a good fix for this? I've run into the same issue. The inter-digit delay is about 2 seconds, and any "Delay Between Codes" set in SageTV just adds to the already too long a delay.

For more details on my system, and steps already taken, you can see my post HERE.