USB-UIRT Forum

--------------------------------------------------------------------------------

I use Sage TV and sometimes when I select a channel from the guide or I manually input into the remote and the USB UIRT sends the commands to slow the STB tunes to the closest channel it can find. For example I select 182 from guide the USB UIRT inputs 82. So now the channel I'm viewing is 82 but Sage thinks its 182. When this happens sometimes if I press stop and then select it again it will re tune on another STB. However most of the time (after pressing stop) when I re select the same channel it doesn't do anything. This also happens with recordings. Sage often records the wrong show because of this issue. Any ideas? THANX!

Youll want to try changing the timing setting is Sage. Increase or decrease the delay between digits to see if this helps

Jon

Ever get a good fix for this? I've run into the same issue. The inter-digit delay is about 2 seconds, and any "Delay Between Codes" set in SageTV just adds to the already too long a delay.

For more details on my system, and steps already taken, you can see my post HERE.