USB-UIRT Forum

I'm sure this has been discussed but I'm not really sure what the feature is called so can't really search on it--anyways say if i'm watching channel 3--how do I configure the usb-uirt to NOT send a signal at the end of the hour if I'm staying on the same channel?

Our cable has a pop up channel block that pops up whenever you change the channel and hangs around for a bit afterwards--If we are watching the same channel and there is no need to send the signal, then it gets annoying.. Hope that makes sense.

thx

Nevermind--turns out it was a sage problem:

Answer:

That is controlled by the mmc/always_tune_channel property, but in v3 (and higher of sage) you can change it in Detailed Setup -> Customize. Look for the "Always tune channel" option.--change it to "no"