How do I make it so IR signals only go if channel changes

Having problems? Use this forum to find help!

Moderator: jrhees

How do I make it so IR signals only go if channel changes

Postby menace » Fri Nov 16, 2007 1:27 pm

I'm sure this has been discussed but I'm not really sure what the feature is called so can't really search on it--anyways say if i'm watching channel 3--how do I configure the usb-uirt to NOT send a signal at the end of the hour if I'm staying on the same channel?

Our cable has a pop up channel block that pops up whenever you change the channel and hangs around for a bit afterwards--If we are watching the same channel and there is no need to send the signal, then it gets annoying.. Hope that makes sense.

thx
menace
 
Posts: 2
Joined: Fri Nov 16, 2007 1:22 pm

Postby menace » Fri Nov 16, 2007 1:41 pm

Nevermind--turns out it was a sage problem:

Answer:

That is controlled by the mmc/always_tune_channel property, but in v3 (and higher of sage) you can change it in Detailed Setup -> Customize. Look for the "Always tune channel" option.--change it to "no"
menace
 
Posts: 2
Joined: Fri Nov 16, 2007 1:22 pm


Return to Troubleshooting

Who is online

Users browsing this forum: No registered users and 33 guests

cron