Page 1 of 1

Is there any way to turn off the LED on the uirt?

PostPosted: Sat Jan 09, 2010 6:25 am
by andyd
I really don't need to see the device show it has received a signal every time I've used it. Any way to disable besides putting tape over it

the led is good for testing but annoying when not

PostPosted: Tue Jan 12, 2010 8:14 pm
by brandon0413
The easiest way I know of is to download the LrnHelper tool.
It is a little difficult to locate unless you have a direct link:

Using it you can access the settings for the USB-UIRT including the option to disable the red LED.

I haven't even been able to find any mention of this app on the USB-UIRT page. Kind of wierd but whatever.

You can also access these settings with the plugin for Girder, which seem difficult to locate as well (The settings in Girder that is). I'd tell you how if I could remember. Maybe if I was looking at it.

PostPosted: Sun Jan 17, 2010 4:27 pm
by andyd
Yeah, I was sent the app through email to verify if the device was working. Noticed the settings after running it