Page 1 of 1

USB UIRT Recognition in Windows 7 MCE

PostPosted: Sat Sep 19, 2009 12:48 am
by OzWiz
My USB UIRT is not recognized by MCE in Windows 7. I have seen a couple of similar posts, but no resolution.

I am running v 20216 and can successfully use it with Beyond TV in the same config.

Any ideas?

Thanks
Tom

its a driver issue duh!

PostPosted: Thu Oct 29, 2009 4:18 am
by radicalE
The driver has to Incorporate Microsoft-recommended RC6 IR protocol. I PMed rhess about this. We will see what he does.

PostPosted: Sat Dec 12, 2009 11:05 pm
by bradpvr
I'm guessing you haven't heard anything back?

PostPosted: Thu Jan 07, 2010 10:52 pm
by Datahead
I posted this in another thread but it applies here.

The reason is because the IR interface for MCE is different. They (Microsoft) calls it a "Microsoft ehome infrared Transceiver" In my case it came with the tuner card, remote, above mentioned device. I don't know if the USB-UIRT can act as the ehome transceiver or not though. I am actually using both on my system IE the automation software controls MCE and other stuff in the house via the USB-UIRT and other interfaces.

Ron