Page 1 of 1

Basic setup help with Sage

PostPosted: Sat Aug 22, 2009 8:21 pm
by tvjunkie
I just installed my USBUIRT & drivers, and am trying to get Sage to use it to recognize my Hauppauge 45-key remote, which came with one of my Hauppauge tuners. I ran the driver install and told Sage that I was using "usbuirt with any remote." Now what? How do I tell it to understand the remote commands. I assume there's something I have to run to config, but what? Next step will be setting up my Comcast DTA to respond to it, so help there will also be most welcome.

PostPosted: Sat Aug 22, 2009 8:50 pm
by tvjunkie
Ok, replying to myself here - I figured out how to link the Sage commands to the remote (a bit of RTFM...), so now the only question I have is the DTA setup.