I am just about ready to order the USB-UIRT instead of a SECU16IR device but am a bit confused on how to set up the basic system.
I assume I can run a cable from the jack to a Xantech Amplified block and then run my emittors from the block to various devices. I will have the device in the basement so I plan on using 1 emittor to connect to a PowerMid or something for the blast effect in one room and the other emittor will go to other rooms hopefully as different zones.
I use Homeseer to control my automation so how will it determine the location of an emittor?
Also I assume I will need to mount an IR reciever and tie it to the block so teh USB-UIRT will have a return path for a sent signal from a remote.
Finally do I just need to program the USB device with commands from my harmony remote for a device I do not own and then use those specific commands to activate different sequences.