Page 1 of 1
791-44 AMPLIFIED CONNECTING BLOCK
Posted:
Mon Jan 31, 2005 12:27 pmby W4ZOO
would like to use this Xantech 791-44 for connecting block for the USBUIRT. I will also need to connect one IR output from my Pronto RF base to to use to controll my components.
I have gotten conflicting info from many soeces. But I think this will work. Can you look at the linked PDF and shed any light?
I don't think I will use any other zones or receivers at this point. I'm hoping that the Uirt and my rf remote IR output can live together.
Any input would be nice.
Ken
791-44 AMPLIFIED CONNECTING BLOCK Manual.
http://www.xantech.com/products/i_folder/i_79144.pdf
Posted:
Mon Jan 31, 2005 4:40 pmby jrhees
W4ZOO,
I'm not sure I'm clearn on what you want to do....
Do you want to:
a) Get IR FROM your Connecting block TO the USB-UIRT's receiver, or
b) Get IR Transmitted from the USB-UIRT TO the connecting block for distribution?
-Jon
Posted:
Mon Jan 31, 2005 5:12 pmby W4ZOO
jrhees wrote:W4ZOO,
I'm not sure I'm clearn on what you want to do....
Do you want to:
a) Get IR FROM your Connecting block TO the USB-UIRT's receiver, or
b) Get IR Transmitted from the USB-UIRT TO the connecting block for distribution?
-Jon
"B" I want to connect both the UIRT and My Pronto to the block to distrtibution.
Posted:
Tue Feb 01, 2005 5:49 pmby jrhees
Many people have done this -- you basically need to wire from the USB-UIRT's 1/8" jack to the Distribution block's IR/Signal input.
-Jon
What about V+ and GND?
Posted:
Sat Jul 23, 2005 4:31 amby Guest
I'm trying to get the USB-UIRT connected to a IR-100 amplified block.
IR-100 amplified block:
3 termal screws labeled V+, GND, and SIG, a 9-12VDC, and 4 flashers.
The 9-12VDC and 4 flashers I understand but what about the V+, GND, and SIG?
1. Plugged in a flasher to the 1/8 UIRT (UIRT and flasher light up)
2. 1/8 UIRT to the SIG. Plugged in a flasher into the block (Flashers do not light up. UIRT does light up)
How do I connect these?
Thanks,
Chris
Posted:
Sat Jul 23, 2005 5:41 amby jrhees
You need to wire the 1/8 barrell to GND and the 1/8 tip to SIG.
-Jon
Posted:
Sat Jul 23, 2005 6:46 amby Guest
Worked like a charm. Thanks for the info!
Posted:
Sun Oct 02, 2005 4:12 amby jkim
jrhees wrote:Many people have done this -- you basically need to wire from the USB-UIRT's 1/8" jack to the Distribution block's IR/Signal input.
-Jon
Is there a distance limitation to this?
Thanks.
Posted:
Tue Oct 04, 2005 3:16 amby jrhees
You should be able to run a cable from the emitter jack > 50 ft without problem.
-Jon