Problem in Girdir learning mode
Posted: Fri Oct 27, 2006 11:18 pmI have a new uirt and took the occasion to upgrade to girder4.
I have a Harmony 680 that is set up for Windows Media Ctr. I try to add a remote and go into learning mode in Girder.
Every press of the same button on the remote generates new ir commands.
For example: i try and learn the Play command. I press play on the remote and 2 commands appear as learned. I press the same key again and 2 new commands are learned. I hold the play key down and the page quickly fills up with unique commands.
Changing the config on the Girder plug-in page does not alter this.
I only want one key associated with play. I played with the
I pulled out other remotes and they seem to do the same thing.
I have already run the snapstream setup. It seems to blast OK but not receive.
Any ideas? Is the new uirt hosed?
Thanks in advance,
Bruce
I have a Harmony 680 that is set up for Windows Media Ctr. I try to add a remote and go into learning mode in Girder.
Every press of the same button on the remote generates new ir commands.
For example: i try and learn the Play command. I press play on the remote and 2 commands appear as learned. I press the same key again and 2 new commands are learned. I hold the play key down and the page quickly fills up with unique commands.
Changing the config on the Girder plug-in page does not alter this.
I only want one key associated with play. I played with the
I pulled out other remotes and they seem to do the same thing.
I have already run the snapstream setup. It seems to blast OK but not receive.
Any ideas? Is the new uirt hosed?
Thanks in advance,
Bruce